Homeowners experience different levels of electrical failures in their homes. To a small percentage, the problems are related to the electricity company, but the greater percentage is related to wiring and connection issues within the house. Your appliances might fail to work because there is not enough power to make the appliance work. Old sockets and electrical wiring may fail to serve the power needs of a modern home. Every small electrical failure in the house should be addressed.
Frequent bulb burnout
You may have noticed your electrical bulb blows out a few days after replacement. This is a warning that you need to look for a licensed electrician near you fast. The problem is a loose connection in your socket or the bulb holder is not tightly connected to the electricity supply. Another problem could be insulation making the connection to overheat and thereby breaking the power. If the problem is not corrected fast, it could lead to a fire.
No power in the sockets
Your house lighting system could be working perfectly, but you notice there is no supply in the sockets anytime you want to use an appliance. It means power could have tripped due to poor connection. The circuit breaker could have tripped and switched off the supply to the sockets. Tripping can also cause wires to melt due to overheating and your outlets become dead. To avert a greater problem, look for the best electrician near me to correct the issue.
Normally, your power outlets should not be warm but there are moments when you feel a socket is warm upon touch. An item cannot be warm unless there is heat being produced within it or around it. Do not hesitate to call your local electrician on call because it means there is a connection problem within the socket and wires are touching or are too close to each other. If the wires finally connect, your socket can blow out. Another challenge shall be a power surge which can blow off all your electrical appliances anytime you plug them into the socket.
Over bright or over dim lighting
This is a common problem that occurs in many homes and you notice your bulbs suddenly become too bright or sometimes too dim. The problem could be with the power supplier due to the power surge in the main lines. In most cases, your circuit breaker should switch off when the voltage is higher than normal. If the breaker is faulty, it will not switch off.
Constant tripping of the circuit breaker
Constant tripping of the breaker means your appliances are using too much than the amperes available. The power gets overloaded and to avert a disaster, the breaker switches off. Another problem could be the breaker is wet and each time a surge builds inside, it trips.
Your licensed electrician is a call away
Many small electricity issues can happen in your home and might lead to a major problem if it’s not corrected fast. If you have recently noticed unusual problems with your electricity connection, you need a professional to inspect and correct the problem before it becomes a disaster. Call our electrical service contractor at (818) 492-4115